Fuse Boards & Consumer Units

The Fuse board is the heart of your home’s electrical installation and is crucially important. You should make sure you know where it is in case you ever need to turn the electricity off in an emergency. They are used to control and distribute electricity around your home as well as keeping you and your family safe.

CONTACT US

REASONS TO UPGRADE YOUR FUSE BOARD

  • Your fuse box is obsolete or faulty.
  • Your fuse box is overloaded.
  • Additional power Is required for a house extension or loft conversion.
  • You seek the piece of mind gained from the additional RCD protection.
  • If your fuse box has a wooden back, cast iron switches, or a mixture of fuses it is likely that it dates back to before the 1960s and will need to be replaced.

THE JARGON EXPLAINED

Main Switch –
This allows you to turn off the electricity supply to your home. You might have more than one mains switch, for example if your home has electric storage heaters. In this case you may have a separate fuse box.

Residual Current Devices ( RCD’s ) –

These are switches that trip a circuit under dangerous conditions, and instantly disconnect the electricity. If your home has one or more RCD, test them regularly. Just follow the instruction label, which you should find near to the RCD. It should read as follows:
This installation, or part of it, is protected by a device which automatically switches off the supply if an earth fault develops. Test every three months by pressing the button marked ‘T’ or ‘Test’.
Testing the button every three months is important. The device should switch off the electricity. You should then switch it back on to restore

the electricity. Do not hold the test button for a long period if the RCD does not trip. If it doesn’t switch off the electricity when you press the button, contact a registered electrician.

Circuit Breakers ( MCB’s ) –
These are automatic protection devices in the fusebox that switch off a circuit if they detect a fault. They are similar in size to fuses, but give more precise protection. When they ‘trip’, you can simply reset the switch. But make sure you correct the fault first.

Fuses ( found in the absence of MCB’s ) –

Re-wirable fuses have a piece of special fuse wire running between two screws. When a fault or overload current flows through the fuse wire, it will become hot and melt. The melted fuse breaks the circuit, disconnecting the faulty circuit and keeping you safe.

IF YOU HAVE A PROBLEM WITH YOUR FUSE BOARD, GET IN TOUCH